← General
0

General

BOM check: when will it support DigiKey?

answered

Do you guys have an ETA for when the BOM check will support DigiKey? Right now it's telling me it only supports Mouser or Adom stock as a source.

Accepted answer John Lauer@johnvia Claude Code View in thread ↓

Thanks for flagging this, Glenn, and sorry: that was our mistake, not a missing feature. AI Flow's BOM check (adom-aiflow sourcing check) treated the default fab profile's preferred suppliers (Mouser and Adom stock) as the only allowed sources. It should never have refused a DigiKey part.

Fixed in AI Flow 0.2.23, live now:

  • Any distributor works on every fab profile. DigiKey, Mouser, Arrow, LCSC, parts you already have on hand: none of them fails the check.
  • Preferred sources are suggestions. A part that isn't from the fab's preferred source is listed as a consigned part, meaning one you buy yourself and send to the fab with the order. Every fab accepts those, including JLCPCB.
  • It tells you when the same part is available from the preferred source. For each consigned part, AI Flow looks up the exact MPN there. If it's in stock, it gives you the part number and quantity, so you can switch and skip sending parts in.
  • The check still flags real problems: a part with no MPN, a board reference missing from the BOM, or stock too thin for your build quantity.

Just tell your AI "give me the latest adom-aiflow" and run your BOM check again.

2 replies

Colby Knox@kcknox

Our wiki components carry Mouser, DigiKey, and LCSC numbers. The BOM check just only reads the one source written on each BOM row, and on the fab profile it only accepts Mouser or Adom stock there. We're fixing it to accept DigiKey and use the part's other numbers. For now, switching those rows' source to Mouser (the Mouser part number is on the same wiki page) gets them through. Thank you for the question!

John Lauer@johnvia Claude Code

Thanks for flagging this, Glenn, and sorry: that was our mistake, not a missing feature. AI Flow's BOM check (adom-aiflow sourcing check) treated the default fab profile's preferred suppliers (Mouser and Adom stock) as the only allowed sources. It should never have refused a DigiKey part.

Fixed in AI Flow 0.2.23, live now:

  • Any distributor works on every fab profile. DigiKey, Mouser, Arrow, LCSC, parts you already have on hand: none of them fails the check.
  • Preferred sources are suggestions. A part that isn't from the fab's preferred source is listed as a consigned part, meaning one you buy yourself and send to the fab with the order. Every fab accepts those, including JLCPCB.
  • It tells you when the same part is available from the preferred source. For each consigned part, AI Flow looks up the exact MPN there. If it's in stock, it gives you the part number and quantity, so you can switch and skip sending parts in.
  • The check still flags real problems: a part with no MPN, a board reference missing from the BOM, or stock too thin for your build quantity.

Just tell your AI "give me the latest adom-aiflow" and run your BOM check again.

Accepted answer