I spent a few hours at the weekend trying to replicate the Fusion demo example (12V/5V buck converter) but Fusion Electronics is such a buggy mess that I gave up in the end. By this time I'd been reduced to running one monitor and restarting Fusion several times. I've not used FE before and it sounds as if my experience isn't unusual. To be clear, this wasn't an Adom issue. I won't waste any more of my life playing with Fusion Electronics - the mechanical CAD/CAM is very good though.
Then I let Claude/VCS install Kicad and the Kicad bridge, which it did quickly and behind the seams. The demo then proceeded perfectly and outputted the hoped-for project, all the way to the 3D PCB and manufacturing files. I believe this Adom/Kicad project has been run previously at Adom but even so it ran seamlessly.
At this point I was ready to try out a "real" project. I defined the requirements and provided a DXF for the board outline, then kicked it off. This was a fairly simple circuit - converting the output from a pressure sensitive resistor (PSR) to a 0-5V voltage and a digital output when a minimum threshold was reached. It's a torch-mounted "TIG button" for turning on the arc of a TIG welder and controlling the arc current by finger pressure. Again, the circuit design, tracking and layout was all done by the agent with very little input needed from me. The detailed circuit design looks pretty good to my experienced eyes.


I've placed the order with JLCPCB for 5 fully assembled PCBAs which should arrive here in the UK within a week. The entire process, including uploading the manufacturing files was done by the tool, with me reviewing and approving critical steps (including payment!). Total cost is $81 including carriage, taxes etc delivered to the UK on a 2 day service. This could have been reduced to $66 if I'd done some further parts substitution but at this point I called it.
Total time was:
- circuit design compt selection (checking LCSC available stock and pricing) ~30 mins
- input from me (PCB outline, edge connector fingers etc) ~25 mins
Layout (placement, routing, ground plane, silkscreen, DRC etc) ~90 mins - simulations (currents, field, thermal, electronic - which found and fixed an issue) ~40 mins
- JLCPCB export, footprint fixes, quote, order setup) ~45 mins
I've been developing embedded power electronics products for 40+ years now, using the likes of Mentor, Cadstar, Altium and EsayEDA. Although this was a pretty simple, non-critical circuit and there is doubtless more work to be done to tackle more complex and demanding applications, it's clearly showing a lot of capability in its current form.
Pretty impressive!